Cu掺杂对有序Sr3YCo4-xCuxO10.5+δ多晶的结构与物理性能的影响

采用固相反应法制备了四方Sr3YCo4-xCuxO10.5+δ(x=0~1.0)多晶。用热重-差示扫描量热分析,X射线衍射研究了多晶的有序化相变及结构。在固溶范围内(x=0~0.4),观察到有序峰(103)和(215),说明四方Sr3YCo4-xCuxO10.5+δ多晶为超结构,这是由于合成时在1000℃以上发生了吸氧(δ)有序化相变；当x=0.6~1.0时,978℃时在晶界处形成了单斜杂相,破坏了Sr3YCo4-xCuxO10.5+δ多晶的有序。当x=0~0.4时,多晶呈半导体输运行为。随着Cu掺杂量的增加,Co4+提供的空穴载流子浓度增大,电阻率明显下降；由于Cu的固溶,自旋熵增加,载流子浓度和自旋熵的共同作用使x=0~0.2多晶的热电势不变,x=0.4的热电势降低。并且Cu掺杂导致的晶格畸变使Co3+离子由高自旋态转变为高/低自旋混合态,磁化强度和铁磁转变温度(Tc)降低,磁结构由G-型反铁磁转变为铁磁。在进行二次烧结后,300K时电阻率明显降低,热电势为一次烧结的2倍,可能是二次烧结使多晶的有序化程度增大,提高了铁磁有序排列。     

离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

Characteristic tryptic peptides and gelling properties of porcine skin gelatin affected by thermal action

Thermal action in extraction process had effects on characteristic tryptic peptides identification and gelling properties of porcine gelatin. SDS-PAGE, HPLC-LTQ/Orbitrap high-resolution mass spectrometry, texture analyser and rheometer were used to evaluate collagen depolymerisation degree, characteristic tryptic peptides and gelling properties of gelatins prepared in various thermal actions. Results showed that with increasing temperature and time, depolymerisation degree enlarged, while gel strength, gelling and melting temperature decreased. Mass spectra showed that 47 and 49 common characteristic tryptic peptides were identified in gelatins extracted at 50 °C and 100 °C with various times, respectively. Moreover, 34 common characteristic tryptic peptides were identified in all gelatin samples. Further comparison between this work and our previous investigations yielded 20 common characteristic tryptic peptides, which stably exist in various thermal actions. These common characteristic tryptic peptides may be very helpful for the accurate authentication of porcine gelatin.     

Effects of red-wine grape pomace on the quality and sensory attributes of beef hamburger patty

This study was conducted to evaluate the effect of red-wine grape pomaces on the quality and sensory attributes of beef hamburger patties. Both phenolic content and antioxidant activity were assessed using Syrah, Merlot and Cabernet Sauvignon pomaces. Following the assessment, hamburger patties were prepared with Merlot pomace at 0%, 2% and 4% for the patty quality and sensory attributes. Grape seeds possessed significantly higher phenolics and antioxidant activities over the seedless pomace (P < 0.05), whereas no significant difference was found for phenolics and antioxidant activities within the seeds and seedless pomaces. The patty pH decreased as the pomace was added for 2% and 4%. Colour values (L*, a* and b*) of patties lowered as the pomace was added. Allo-Kramer shear force and hardness values increased while cooking yield decreased (P < 0.05) with the addition of pomace. No significant difference between control and Merlot patties was found for flavour, juiciness and colour, whereas lower sensory attributes were observed for texture, taste and overall acceptability. It is observed that the addition of fermented red-wine grape pomace provides hamburger patties with health promoting factors such as antioxidant and other functional components, but it also provided darker, sourer and lower cooking yield.     

从蚕的生命到艺术：中国古代生命观的哲学表达

中国考古出土的蚕业实物及蚕的艺术形象比较丰富,蚕的艺术形象如蚕纹、陶蚕蛹、牙雕蚕、玉石蚕、铜蚕、金蚕等,可统称为"蚕的模拟形态"。对蚕的模拟形态的功用,已有的诸多解释都有待完善。研究表明,蚕的模拟形态或艺术形象表达的功用或为饰品,或为装饰图案,或有待进一步考究。但无论哪种功用,用"蚕"这一形象都蕴含了特有的用意。通过对中国古代生命观的考察,文章认为蚕的艺术形象折射出相应的中国古代哲学生命观,即中国古人追求的死而复生、生生不息、羽化成仙、长乐无极等观念。     

Combining a new baseboard radiator with a fan coil system for improving heating performance and reduce energy consumption

In the present work, the heating performance of a new system combined with a new modified baseboard radiator and fan coil is investigated. Using longitudinal fins with special geometry and also forced airflow at the end of the system causes that at the lower inlet water temperature compared with the conventional models, higher heat output rate be obtained. The heat output rate of the new modified system is obtained by experimental metrology based on the European Standard No. EN-442. Temperature and velocity distribution in the room space is done by simulation of the modified system in the Flovent software. Computational fluid dynamics (CFD) results are validated against experimental results and there is a good agreement between them. Also, the energy consumption of the system during the winter season is calculated in TRANSYS software. Experimental results show that the heat output rate of a new modified heating system with inlet water temperature in the range of 45–55°C is on average 4.17 times higher compared with the conventional model. CFD simulation also showed that the combined system provides good thermal comfort conditions. Energy consumption of the new system reduced about 13% compared with conventional models.     

Extinction and Non-extinction of Solutions to a Fast Diffusion p-Laplace Equation with Logarithmic Non-linearity

This paper deals with a class of fast diffusion p-Laplace equation with logarithmic non-linearity in a bounded smooth domain with homogeneous Dirichlet boundary condition. By using energy estimates and some ordinary differential inequalities, we study the conditions on extinction and non-extinction of global solutions. The results of this paper extend and complete the previous studies on this equation.

     

On the Stability of a Degenerate Wave Equation Under Fractional Feedbacks Acting on the Degenerate Boundary

Journal of Dynamical and Control Systems - In this work, we are concerned with the study of stabilization of one-dimensional weakly degenerate wave equation utt ? (xγux)x = 0 with x...     

Analysis of pressure and heat distribution in a dilating or contracting filter chamber with two outlets using multivariate spectral quasilinearization method

The development of efficient filters is an essential part of industrial machinery design, specifically to increase the lifespan of a machine. In the filter chamber design considered in this study, the magnetic material is placed along the horizontal surface of the filter chamber. The inside of the filter chamber is layered with a porous material to restrict the outflow of unwanted particles. This study aims to investigate the flow, pressure, and heat distribution in a dilating or contracting filter chamber with two outlets driven by injection through a permeable surface. The proposed model of the fluid dynamics within the filter chamber follows the conservation equations in the form of partial differential equations. The model equations are further reduced to a steady case through Lie's symmetry group of transformation. They are then solved using a multivariate spectral-based quasilinearization method on the Chebyshev–Gauss–Lobatto nodes. Insights and analyses of the thermophysical parameters that drive optimal outflow during the filtration process are provided through the graphs of the numerical solutions of the differential equations. We find, among other results, that expansion of the filter chamber leads to an overall decrease in internal pressure and an increase in heat distribution inside the filter chamber. The results also show that shrinking the filter chamber increases the internal momentum inside the filter, which leads to more outflow of filtrates.     

A numerical study on nonlinear DPL model for analyzing heat transfer in tissue during thermal therapy

In the present paper, therapeutic treatment of infected tumorous cells has been studied through mathematical modeling and simulation of heat transfer in tissues by using a nonlinear dual-phase lag bioheat transfer model with Dirichlet boundary condition. The components of volumetric heat source in this model such as blood perfusion and metabolism are assumed experimentally validated temperature-dependent function, which gives more accurate temperature distribution in tissues through this model. We have used the finite difference and RK (4, 5) techniques of numerical methods to solve the proposed problem and obtained the exact solution in a particular case. After comparison, we got a good agreement between them. We have used dimensionless quantities throughout this paper. The effect of relaxation and thermalization time with respect to dimensionless temperature distribution has been analyzed in the treatment process.